As part of its investigation, OPR will assess compliance with our policies on the part of the Border Patrol agents involved in this incident. OPR has referred initial investigative information to the United States Attorney’s Office for the District of New Mexico, which has not yet commented on this matter. This use of deadly force is being investigated by CBP’s Office of Professional Responsibility. The driver struck the agent a second time as he stood over him and was preparing to do so again when three other agents fired their service weapons, striking the driver. The driver advanced to meet the agent, who fell to the ground, swinging a wooden club multiple times and striking the agent on the ground. After walking for several minutes with the driver while attempting to persuade him to stop, an agent moved in to attempt to physically restrain the driver. After a vehicle pursuit, the driver exited the vehicle and was confronted by Border Patrol agents. Border Patrol checkpoint located on Interstate 10 approximately 23 miles west of Las Cruces, New Mexico, on April 2 and began to follow. That footage is being released today, in compliance with CBP policy and the May 25, 2022, Executive Order on Advancing Effective Accountable Policing and Criminal Justice Practices to Enhance Public Trust and Public Safety.Ī Border Patrol agent observed a sports utility vehicle circumvent a U.S. This incident was captured on three agents’ body worn cameras. The video may be viewed on the Body-Worn Camera Video Releases page and the in-custody death statement on the incident can be found on the Newsroom page. Customs and Border Protection released body-worn camera footage today from a deadly use of force incident which occurred near Las Cruces, New Mexico, on April 2, 2023. Be sure to identify any in-wall pipes or wiring before drilling the hole or find a local pro to install it for you.WASHINGTON – U.S. Drill a ⅞" hole through the wall and run the cable through it to plug it into an indoor outlet.Keep the cable out of reach by routing it through the top of the door. Run the flat USB cable through a doorway and plug it into an indoor outlet.If your Nest Cam Outdoor is plugged into an outdoor outlet, install a lockable "while-in-use" or "water and dust" cover that will help prevent it from being unplugged.This can affect it's sensors and performance, and may void the warranty. Paint the power cable and clips to match your home.Run the cable along an edge, eave or other hidden area.Use a clip near the camera to prevent someone from yanking on the cable to dislodge the camera.Use the included clips and screws to fasten the cable to a wall or surface.This camera's cable is permanently attached to the camera.This can affect its sensors and performance, and may void the warranty. Painting the power cable and clips to match your home will make your camera installation less obvious.ĭon't paint or cover the camera.To make the cable less visible, you can run it along an edge, eave, or other hidden place. ![]() The clips will make it difficult for someone to dislodge or steal the camera.If you need to run the power cable along your exterior wall be sure to use the included cable clips to secure it. Be sure to identify any in-wall pipes or wiring before drilling the hole or find a local pro to install it for you. ![]() Drill a 1/2-inch hole in your wall, run the cable through it, and plug it into an indoor outlet. Google Nest Cam IQ Outdoor This camera has a locking base that can completely conceal the power cord. Check your local hardware store for availability. ![]() Install cable clips to help keep the power cord attached to the wall.Run your camera's power cable behind furniture or shelving so that it's harder to spot and unplug.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |